Electronic Power Supply Circuit Trainer Model ETR 030
Electronic Power Supply Circuit Trainer Model ETR 030
Model ETR 030A – HALF WAVE, FULL WAVE & BRIDGE RECTIFERS
Model ETR 030B – REGULATED POWER SUPPLY CIRCUIT TRAINER-I
Model ETR 030C – REGULATED POWER SUPPLY CIRCUIT TRAINER-II
Item Description
Model ETR 030A:
Capacitor Bank consisting of Two Capacitors of 220μf each
Center Tapped Transformer Secondary providing 12V-0-12V
Model ETR 030B:
Load Block consisting of One Resistance and One Potentiometer of 5K Center Tapped Transformer Secondary providing 12V-0-12V
Model ETR 030C:
Load Block consisting of One Resistance and One Potentiometer of 5K
Center Tapped Transformer Secondary providing 12V-0-12V
One LED indicator to indicate Power input.
Technical Specifications
Model ETR 030A
– One LED indicator to indicate Power input.
– On-board Circuits
– Half wave circuit involving one 1n4007 diode.
– Full wave Circuit involving two 1n4007 diode.
– Bridge Circuit involving one 1n4007 diode.
– Filter Circuit
– All interconnections are made using 2mm banana Patch cords.
– Bare board Tested Glass Epoxy PCB is used.
– Set of 2mm Patch cords for interconnections
Model ETR 030B
One LED indicator to indicate Power input. On-board Circuits
– Zener Regulator (Shunt) with Current Boost Transistor.
– Series Regulator.
– LM723 Regulator. All interconnections are made using 2mm banana Patch
cords. Bare board Tested Glass Epoxy PCB is used. Set of 2mm Patch cords for
interconnections
Model ETR 030C
On-board Circuits
– Zener Shunt Regulator.
– Voltage Multiplier.
– Current Regulator.
All interconnections are made using 2mm banana Patch cords.
Bare board Tested Glass Epoxy PCB is used.
Set of 2mm Patch cords for interconnections
See also different:
Sci-tech Variable Forces Apparatus Model MT 092 is a simple lifting mechanism with obvious nonlinear characteristics. A suspension cord carrying a loaded trolley at mid span is tensioned by passing the cord over a pulley at one end and down to [...]
