Apparatus for Determining Strain Gauge Factor of Strain Gauges Model MT 058
Apparatus for Determining Strain Gauge Factor of Strain Gauges Model MT 058
Sci-tech Apparatus for determining the Gauge Factor of Strain Gauges Model MT 058 allows the measurement of deflection and strain in a bar and the determination of the gauge factor of strain gauges
Sci-tech Apparatus for determining the Gauge Factor of Strain Gauges Model MT 058 is used to measure deformation in a bar by means of a dial gauge and four strain gauges in full bridge configuration. The gauge factor is calculated through several measurements taken with the strain gauges.
The unit consists of a bar supported on ball bearings at two points, allowing to apply a purely bending stress. The mechanical load application device includes a spindle, a cross-arm and a flywheel. This device allows to load the bar and a dial gauge allows to measure the deflection in the bar. At the same time, two strain gauges on the tension side and two strain gauges on the compression side measure the strain on the surface of the bar.
The unit includes an electronic console with a digital display to show all readings.
The gauge factor can be calculated from the deflection of the bar by the strain gauge measurements.
| Size: | 95cm x 45cm x 75cm (LxWxH) |
| Weight: | 15 kg |
Item Description
The gauge factor (or strain factor) of a strain gauge is the ratio of relative change in electrical resistance to the mechanical strain. The signal obtained with a strain gauge is processed by a strain measurement amplifier to visualize the resulting strain in a display.
To evaluate the measurements given by the measuring device and the reading shown in the display, it is necessary to know the gauge factor of the strain gauge.
Sci-tech Apparatus for determining the Gauge Factor of Strain Gauges Model MT 058 allows the measurement of deflection and strain in a bar and the determination of the gauge factor of strain gauges
Sci-tech Apparatus for determining the Gauge Factor of Strain Gauges Model MT 058 is used to measure deformation in a bar by means of a dial gauge and four strain gauges in full bridge configuration. The gauge factor is calculated through several measurements taken with the strain gauges.
The unit consists of a bar supported on ball bearings at two points, allowing to apply a purely bending stress. The mechanical load application device includes a spindle, a cross-arm and a flywheel. This device allows to load the bar and a dial gauge allows to measure the deflection in the bar. At the same time, two strain gauges on the tension side and two strain gauges on the compression side measure the strain on the surface of the bar.
The unit includes an electronic console with a digital display to show all readings.
The gauge factor can be calculated from the deflection of the bar by the strain gauge measurements.
See also different:
Sci-tech Saturation Pressure Unit Model BSG 020 consists of a water boiler, including a Sci-CalR computer-controlled immersion heating element, and a sight glass to observe the boiling patterns in the water surface and control the water level [...]
