DIGITAL/ANALOG TRAINER KIT MODEL DTK-01E
DIGITAL/ANALOG TRAINER KIT MODEL DTK-01E
- Bread Board Area
– It consists of Four Distribution Strip of 100 tie points and Two Terminal Strip of 640 tie points
totaling 1680 tie points.
– Located at the center of the PCB, with provision to remove it.
– Can be replaced with the Experimental Boards mentioned below.
Item Description
- Indicators
– 16 TTL/CMOS Logic Level Inputs with Dual Color LED indication for logic low and logic high
– 16 LED for output indication.
– 2 Digit 7 Segment Displays with BCD to Seven segment Decoder
– LED BAR Graph with 10 LED Indicators to display 0-5V input
Technical Specifications
- Onboard Interfaces
– DPM provided with mode selection: DC volt/current 200mA/200V
– 8 ohms, 0.5 Watt Speaker
– Variable potentiometers of 1K, 10K 100K provided on board
– Computer Interface adapter (25 Pin D-Type connector) outputs of which are brought out on 25 Nos.
of Banana Sockets facilitates in connecting with IEEE 488 or RS-232 Serial Port of PC
– LED BAR Graph with 10 LED Indicators to display 0-5V input - Fixed Clock Generator
– 1Hz, 5Hz, 100Hz, 1KHz, 10KHz, 100KHz, 1MHz & 10 MHz. - Pulse Generator
– Two No. of SPDT Pulser Switches provided.
– It provides bounce less pulses of Low to High and High to Low transitions. - Logic Probe
– Logic Probe to indicate Low/High Pulses up to 1 MHz
– LED indicators to indicate Logic High, Low - Function Generator (using IC 8038).
– Provides Sine, Square/TTL and Triangular output waveforms.
– Frequency variable from 1Hz.-200 KHz in SIX steps.
– Amplitude and Frequency can be varied
– Output Voltage 20V p-p max.
See also different:
Forces in a Crane Jib Model MT 014
Sci-tech Forces in a Crane Jib Model MT 014 represents a planar central force system in which multiple forces act on a single point of application. Based on the example of a crane jib, forces are determined graphically and experimentally: resu [...]
PWM DC Motor Control Circuit Trainer Model ETR 033
Sci-tech PWM DC Motor Control Circuit Trainer Model ETR 033 is a DC Motor driver/controller designed to be used as a training aid in courses of industrial electronics and electr0technical studies The trainer is suitable for use on desktop. The [...]
