Technical Specifications

– Built in Power Supply DC. Power Supply : 5V / 1A ± 12V, 500mA
Variable : 0 – + / -12V 150mA, AC 12 – 0 – 12, 150mA AC
– Built in Function Generator
Output Waveform – Sine, Triangle & Square / TTL
Output Frequency – 1 Hz to 200KHz in 6 ranges, with amplitude & frequency control pots. O/P Voltage 20V p-p max.
– Clock Generator : 10 MHz TTL clock.
– Input Data Switches and output LED status indicators for High/Low indication (15+1) No.
– Pulser switches (2 nos.) With four debounced outputs..2no.
– Fixed TTL (5V) clocks : 4 Nos. 1KHz, 100Hz, 5Hz, 1Hz
– Logic probe to detect High/Low level pulses upto 1MHz, With bi-colour LEDs to indicate status.
– 2 digit 7 segment display with BCD to 7 segment decoder.

– Onboard speaker – 8 Ohms, 0.5 Watt (1no.)
– Onboard POTS………….1K(1no.) & 1M(1no.)
– Built in bread board panel with 1280 tie points and 400 distribution points totalling to 1680 points along with 4mm banana sockets fortapping from the trainer +5V, +12V GND for the circuits to be assembled on bread board using single stand (#22/24)wire.
– Computer Interface Adapter
Facilitates connecting your trainer to either IEEE 488 or RS232 com port of PC using 25 pin (male) D connector through 25 nos. of banana sockets. Optionally a 16 pin ZIF may be provided in place off ‘D’ connector.
– Mechanical Dimensions
(A) Master Unit : 400mm(W), 125mm(H), 270mm(D)
Net weight: 8Kg. Gross wight: 10Kg.
(B) Panel : 215mm(W), 165mm(H), 40mm(D)
Net weight: 700 gm approx.
– Operating Voltage – 230V +/- 10%, 50Hz/72VA.

– LED BAR graph with 10 LED indicator to display 0-2.5V or 0-4V input.
– Onboard DPM is provided with mode selection. DC volt / current – 200mA/20V