Technical Specifications

Digital IC Trainer

Specifications

Indicators

– 10 TTL/CMOS Logic Level Inputs with Dual Color LED indication for logic low and logic high

– 10 LED for output indication.

Clock Generator

– Fixed Clock generation of 1Hz, 10Hz, 100Hz, 1 KHz, 10 KHz, and 100 KHz & 1 MHz.

Pulse Generator

– Logic Pulsar provides single pole double throw bounce less pulses of Low to High and High to Low

transitions.

Logic Probe

– Logic Probe facility provided with LED indicators to indicate Logic High, Low & Tri-state.

Bread Board Area

– Two Distribution Strip of 100 tie points each totalling 200 tie points.

– One Terminal Strip of 630 tie points.

Display

– Three digit seven-segment LED display.

Sockets on board

– 14 Pin Socket- 8Nos.

– 16 Pin Socket- 3Nos.

– 20 Pin Socket- 1No.

One IC each of 7400, 7402, 7408, 7432, 7404, 7490,7495, 7486, 7447 & Two Nos. of IC 7476.

Power Supplies

– Fixed DC Power Supply: +5V, ±12V.

Interconnections

• All interconnections are made using 2mm banana Patch cords.
• All ICS are mounted on IC Sockets.
• Bare board Tested Glass Epoxy SMOBC PCB is used.
• Set of 2mm Patch cords for interconnections.

• User’s Manual with sample experimental programs.

 

Linear IC Trainer

Specifications

Indicators

– 4 LED’s for output indication.

On board LINEAR IC’s

– 4 Timer IC 555 (2 Nos.).

– Op-amp IC 741 (4 Nos.)

– Sample & Hold IC-398 (1No.)

– Opto Coupler MCT2E (1No.)

– Voltage Controlled Oscillator 566 (1No.)

– Comparator IC 710 (1 No.)

On board Interfaces

– Resistor Bank ranging from 10 ohm to 1M ohm (42 Nos.)

– Capacitor Bank ranging from 1Kpf – 1micro farad (23 Nos.)

– Voltage regulators one each IC-7805, 7905, 317

– Transistors one each NPN-BC547, PNP-BC188

– Diodes 1N 4007 (4 Nos.), Diode 1N4148 (2 Nos.) &

Zener Diodes one each 1.2V, 5.6V, 7.5V

– 12V SPDT Relay with outputs NC, NO & Common terminated on 2mm banana sockets

– One 8ohm Speaker with outputs on 2mm banana sockets

– One five mm LED with outputs terminated on 2mm banana sockets

Potentiometers

– Variable potentiometers of 1K, 10K 100K provided on board

Bread Board Area

– Two Distribution Strip of 100 tie points each totalling 200 tie points

– One Terminal Strip of 630 tie points

Function Generator (using IC 8038).

– Pr o v i d e s Si n e , Sq u a r e a n d Tr i a n g u l a r o u t p u t waveforms.

– Frequency variable from 0-200 KHz in FIVE steps.

Power Supplies

– Fixed DC Power Supply: +5V, ±12V.

– Variable DC Power supply of +1.2V to +15V & -1.2V to –15V.

– AC Power Supply of 15V-0-15V

Interconnections

– All interconnections are made using 2mm banana Patch cords.

• All ICS are mounted on IC Sockets.
• Bare board Tested Glass Epoxy SMOBC PCB is used.
• Set of 2mm Patch cords for interconnections
• User’s Manual with sample experimental programs