Chemical Process Control Trainer MODEL PCT 025

The trainer is made of steel frame structure with epoxy coated paint; it is self contained designed which all the component are on one skid. There are three tank, 1st tank is PH mixing tank, both the alkaline and acid solution transfer in the tank, a motorize stirrer installed to speed up the homogeneous mixing process. The metering of alkaline and acid solution is precisely control by chemical dosing pump. PH sensor is continuing monitor the required PH by controlling the rate of dosing pump transfer. Where the PID control function is applied. 2nd tank is buffer tank, which the after mixed solution is transferred. Again the PH sensor is monitoring the PH reading, ORP sensor monitor the effect of PH on the change of solution ORP. And conductivity change relative the PH, Compressed air bubble with rate control and monitor by air flow meter is applied to 2nd tank, studies the change of conductivity VS pH. 3rd tank is dumping tank, the PH reading the measure again before the solution is drain out, if the PH reading is out of the range of DOE requirement, the PH neutralized process is implement, before the solution is discharged. Specifications PH controller Microprocessor based controller, PID function and ON/OFF control Input: 4 to 20mA, output: 0 to 5 Volt Sensor range: pH 0 ~ 14 ORP controller Microprocessor based controller Input: 4 to 20mA, output: 0 to 5 Volt Sensor range: 0 to 20ppm Conductivity Microprocessor based controller Input: 4 to 20mA, output: 0 to 5 Volt Sensor range: 0 to 200μS/cm Dissolved oxygen Input: 4 to 20mA, output: 0 to 5 Volt Range 0 to 20ppm Dosing pump PH control pump: 0 to 20 liter per hour Buffer transfer pump: 0 to 30 LPH Base dosing pump: 0 to 20 LPH Air operated diaphragm pump: 0 to 50 LPM