Analogue to Digital Converter Trainer Model ETR 010ADC
Analogue to Digital Converter Trainer
Model ETR 010ADC
|
|
Key Features
- Converts S/PDIF digital audio (PCM) feed from a compatible device to an analogue stereo audio
- Accepts uncompressed digital audio input
Key Features
- Converts S/PDIF digital audio (PCM) feed from a compatible device to an analogue stereo audio
- Accepts uncompressed digital audio input
Specifications
- 2-channel LPCM (Linear Pulse Code Modulation) at 32, 44.1 , 48, 96 & 192 KHz
- 24-bit S/PDIF incoming bitstream on left and right channels
- Includes digital interpolation filter
- Optical & digital coaxial inputs
- Input select switch, LED Power indication , Compact design
- Supports audio signals up to 24-bit with sampling rates up tQ 92kHz, Low-latency digital filtering, Dynamic Range: 106 dB A-wt
- THD+N (Total harmonic distortion plus noise) rating: -93dB
- Operating Humidity Range: 5 to 90 % RH (no condensation)
- Power Supply :
- Power Consumption : I .Ow (max) Input: Digital Coax or S/PDIF Output: L+R RCA
- Distortion <0.001% @ l kHz at 2V RMS Signal to Noise Ratio > 90dB (20Hz – 20kHz)
- Output Impedance 500Q, Output Voltage I.8V RMS @ Max Input (OdBFS)
- Frequency Response <+/-0.5dB, Chassis Extruded al umi n um (black)
Specifications
2-channel LPCM (Linear Pulse Code Modulation) at 32, 44.1 , 48, 96 & 192 KHz
24-bit S/PDIF incoming bitstream on left and right channels
Includes digital interpolation filter
Optical & digital coaxial inputs
Input select switch, LED Power indication , Compact design
Supports audio signals up to 24-bit with sampling rates up tQ 92kHz, Low-latency digital filtering, Dynamic Range: 106 dB A-wt
THD+N (Total harmonic distortion plus noise) rating: -93dB
Operating Humidity Range: 5 to 90 % RH (no condensation)
Power Supply :
Power Consumption : I .Ow (max) Input: Digital Coax or S/PDIF Output: L+R RCA
Distortion 90dB (20Hz - 20kHz)
Output Impedance 500Q, Output Voltage I.8V RMS @ Max Input (OdBFS)
Frequency Response <+/-0.5dB, Chassis Extruded al umi n um (black)
Interconnections
o All interconnections are made using 2mm banana Patch cords.
o All ICS are mounted on IC Sockets.
o Bare board Tested Glass Epoxy SMOBC PCB is used.
o Set of 2mm Patch cords for interconnections.
o User's Manual with sample experimental programs.
